Hybrid solar inverter Axpert Ultra | 11kW | 48VAxpert Ultra
Hybrid solar inverter Axpert Ultra | 11kW | 48VAxpert Ultra

Inverter Ultra 11kw 48V Solitia Solar Solar Charger 96-346644-01g

[OFF1307]
€875.74
Tax included

The Axpert Ultra 11k is a inverter Solar charger of 11 kW for 48 V batteries that gathers in a single team inverter of pure sine wave, Double MPPT Solar Charger and battery charger from network or generator. Is designed to Isolated homes, installations with unstable network and backup systems, and it admits 12,000 WP of panels distributed in 2 MPPT with a range of 90 to 450 V. What distinguishes it within the Axpert range is its architecture Double entry and double exit: Accept network and generator at the same time with automatic switching between both, and its second AC output can be programmed by voltage, charge status, download time or schedule, to disconnect non-priority loads when the battery low. Charge the battery with up 150 a, delivery 22,000 VA of peak, it incorporates Current transformer for self-consumptionport BMS (RS485, CAN or RS232), WiFi with remote update and supports up 6 teams in parallel.

 

Detailed technical characteristics

General data

  • Model: Axpert Ultra 11k (reference 96-346644-01G)
  • Nominal power: 11,000 VA / 11,000 W
  • Parallel operation: up to 6 units
  • Battery voltage: 48 V DC

AC

  • Nominal voltage: 230 V AC
  • Selectable range: 170-280 V AC (computer equipment) / 90-280 V AC (electronics)
  • Frequency: 50/60 Hz (automatic detection)
  • Check in: electric network and generator, with automatic switching

AC

  • Voltage regulation (Battery mode:) 230 V AC ± 5%
  • POWER OF PICO: 22,000 VA
  • Maximum efficiency: 93%
  • Transfer time: 10 ms (computer equipment) / 20 ms (electronics)
  • Waveform: pure-stenoidal
  • Outputs: double exit AC, the second programmable

Drums

  • Flotation voltage: 54 V DC
  • Overload protection: 63 V DC
  • Battery temperature sensor (BTS:) compatible

Solar charger and BC charger

  • Type of regulator: MPPT
  • Maximum FV power: 12,000 W (6000 W x 2)
  • MPPT range: 90 to 450 V DC
  • Maximum tension in open circuit (VOC:) 500 V DC
  • Maximum FV input current: 27 A x 2 (max 40 a)
  • Maximum current of solar load: 150 A
  • Maximum current current AC: 150 A
  • Maximum total load current: 150 A

Communication and functions

  • Ports: USB, RS232, RS485, Wi-Fi, dry contact, BTS
  • BBS port: RS485, CAN-Bus or RS232
  • Monitoring: WiFi with mobile app and oTA Firmware Update
  • USB on-the-Go: yes
  • External current sensor: integrated current transformer self-consumption
  • Screen: Color LCD 2.8 " with slider and status indicators
  • Optional: GFCI, fast shutdown (RSD) and arc detection (AFCI)

Physical and environmental data

  • Dimensions (PR X AL:) 145 x 438 x 553.6 mm
  • Net weight: 18.4 kg
  • Operating temperature: -10 to 50 ° C
  • Storage temperature: -15 at 60 ° C
  • Humidity: 5 to 95% non-condensation
  • Rules: EC

Benefits of Ultra 11K Axpert

Double entry: Network and generator without external switches

In isolated facilities or with unreliable network it is usual to have a network and a generator set. The ultra Axpert accepts both sources and automatically switches among them, which avoids installing an external switch and simplifies the table.

Second exit to protect autonomy

The second exit AC it can be programmed to disconnect non-essential loads, such as an electric thermos, a pool pump or air conditioning, when the battery low from one level, when exceeding a download time or in certain time slots. Thus the stored energy is reserved for the essential.

Up to 12 KWP panels in two orientations

The 2 MPPT of 6000 W each and the range of 90 to 450 V they allow you to connect large fields of solar panels in long chains, with two different orientations. With 27 A per Entrance, supports high current panels.

150 A load for large banks

With 150 A of solar load or from network, the equipment can quickly recharge banks of lithium batteries 48 v large capacity. Port BMS allows the battery to communicate their limits to inverter.

Scalable up to 66 kW

Up 6 units in parallel, the system can grow, as a guidance calculation, until some 66 kW of nominal power, for large housing, farms or small isolated businesses.

For what installation is it right?

Housing and holdings isolated

It is an option for farms, cottages or holdings offline with high consumption, which need a team capable of managing panels, battery and generator.

Installations with unstable network

In areas with frequent cuts, the team prioritizes solar energy and battery and uses the network or generator as support, with a transfer time of 10 or 20 ms depending on the way.

What to keep in mind

The ultra Axpert is a inverter charger for isolated and backup systems: your technical sheet does not include network connection certifications to inject surpluses. If you are looking for self-consumption with a network, check our inverters hybrid of network connection. Find more options in inverters solar, , structures for solar panels and solar kits of Tienda Solar. In the Blog Tienda Solar you have guides to size isolated systems.

Frequently Asked Questions (FAQ)

1. What is the difference between the Axpert Ultra 11K and the Axpert Max E 11k?

The two have 11 kW, 48 V, 2 MPPT and 150 A load. The Ultra add double entry (network and generator with automatic switching,), double programmable exit, integrated current transformer and options GFCI, RSD and AFCI, and admits 12,000 WP of panels versus 11,000 wp.

2. Can I connect network and generator at the same time?

Yes. The team has double entry and automatically switches between the network and the generator.

3. What is the second way for?

To feed loads that can be disconnected according to the battery voltage, load status, download time or schedule, and reserve the battery for essential consumption.

4. What batteries do you admit?

Batteries 48 V. It has a port BMS by RS485, CAN-BUS or RS232; It is convenient to check the compatibility of the battery model with the manufacturer before installation.

5. Can you inject surpluses to the network?

Its technical sheet defines it as inverter for isolated systems (off-grid) and it does not include network injection certifications. For self-consumption with pouring is recommended hybrid inverter of network connection.

6. How many panels can I connect?

Until 12,000 WP, scattered in 2 MPPT of 6000 W, with a range of 90 to 450 V, , 500 V of maximum tension in open circuit and 27 A per entrance.

Power (kW)
10 - 14.9
Phase Type
Single phase
Max Current Input (A)
15 - 15.99
Compatibility list
Pylontech Force L2
Pylontech US2000C / US3000C / US5000
Pylontech US3000C
Pylontech US5000 / Force L2
Turbo Energy (Slim)

Customers who bought this product also bought: