Full pack Solar assembly 2 solar panels coplanar

To apply the Fischer Solar Plate Facilities, the following steps must be followed: 1. Drill tiles with a reduced scrubbing bit SDS, which hits the anchor base (for example, the SDS short Pointer M drill bit of FISCHER) 2. Before applying the resin, enter the FIS H K sieve by adjusting it to the desired anchor depth and cut off the remaining part. 3. Once the sieve is introduced, the chemical taco applies with the help of an extensionable cannula if the anchor depth is higher than the built-in cannula measured in the resin tube. Always fill the hole with chemical anchor from bottom to top. 4. Insert the STSR fixing rod and after 60min at 20 ° C drying, tighten the washer to prevent water from filtering through the hole. (See the specific drying time in the cartridge) 5. To waterproof the roof, apply the waterproof paint MS with brush or roller to avoid leakage of water by possible cracks in the tiles produced during the fixing process. It covers the surface around the rod and cracks on the tiles. 6. Fix the connection and subsequently the Solar-Light profile. Finally, he adds the pre-assembled hammer head screw and arrow.