Your cart
There are no more items in your cart
Solar panel Jinko Tiger pro 545 wp mono perc
JKM530M7TL4V
€90.96
Tax included
Module / Monocrystalline photovoltaic panel Jinko Solar Tiger Pro of 545WP (144 cells) of Perc technology (Passive Emiter Rear Contact) with 21.13% efficiency. Positive tolerance 0 / + 3% for photovoltaic solar network installations or isolated up to 1500V of the system. Warranty of 10 years of product and 25 years of production.
Solar loaves of the Tiger Pro Monocrystalline series in their different power variants are composed of 72 item solar cells (virtually 144 cells) with 5 BARS BARS technology distributed in 6-column grid and 24 rows. This series of Jinko It has the PERC technology what gives you higher efficiencies making your high-performance solar panels and efficiency
The main bay of the Tiger Pro series in addition to the distribution of the 5 bus bars on the surface of the cells as already provided by the Cheetah series is the application of the PERC technology (Passive Emiter Rear Contact). This technology consists of a surface treatment of the back of the solar panel cell that is responsible for capturing the photons of the wave width that crosses the cell and that is not captured by it to make it revolt and introduce it from new to the cell to generate Additional current For the solar panel 545 WP we emphasize the incorporation of item cells which reduces recombination losses and increases the surrounding result at 1%. With all these technological novelties the solar panel gets a performance higher than 20%.
The main advantages of solar plates The Tiger Pro Mono Perc 545WP series of solar cell split are:
- Reduction of micrographs in the panel because the 5 bus bar of the cells are responsible for their growth
- Cut Cell Technology (heading cell) that decreases electron recombination in the panel, reduces the size of hot spots and improves the performance of the solar plate under partial shading conditions.
- PERC technology that provides the panel of an extra performance of approximately 2% compared to solar boards that do not have such technology.
- Solar panels with very low or null degradation by difference of potential PID.
- PID quality control in the production line for each solar panel
- Surface treatment of anti-reflective crystal that better behavior of the solar plate with diffuse radiation. Crystal with low iron content that dissipates better the incident heat
- Photovoltaic plate with 2,4kpa wind mechanical load capacity of 5,4KPA.
- Solar panel Tested under high corrosion conditions (seberity -b) and certified by TUV
- Very reduced tension coefficient which minimizes the losses of the solar panel when operating at high temperatures.
Features in STC (1000 W / M2, T Cell 25 ° C):
- Power (W)
- 500 - 545
- Height (cm)
- 220 - 229.9
- Width (cm)
- 110 - 119.9
- Frame
- Silver
- Short Circuit Current Isc (A)
- 13 - 13.99
Tap to zoom
