Inverter SolarEdge Home Hub 5.0kW with BackUp
  • Inverter SolarEdge Home Hub 5.0kW with BackUp

Inverter SolarEdge Home Hub 5.0kW with BackUp

€1,714.00
Tax included

Single phase solar inverter of the brand SolarEdge 5kWac supporting the BackUp function via SolarEdge The home interface is BI-EU1P. This inverter of the SEXXXXH series can support up to 200% of the rated AC power at power in the continuous part (12000Wdc) to maximise the AC output.

The BackUp system allows the solar installation to continue feeding the loads in case the grid stops working giving the nominal power of the inverter. The 6.0kW Home Hub inverter allows modular connection of several 400V solar batteries SolarEdge Home (up to 3 batteries).

This inverter has a single MPPT, arc detection system and offers a 12-year warranty with the possibility of extending it to 25 years

Quantity

The inverter series SolarEdge Single-phase Home Hubs have the following advantages:

  • - Single phase inverter for the European 50 Hz network
  • - Weighted solar inverter efficiency of up to 99% during the daily operating cycle
  • - Capacity to connect up to 200% of the nominal inverter capacity in the direct current part (solar panels)
  • - It includes arc detection in the solar installation thus improving the safety and life of the entire system.
  • - Scalable solution with the ability to add up to a total of 3 400V batteries of the series SolarEdge I'm going home.
  • - You need the backup system through SolarEdge Home interface BI-EU1P to operate in off-grid or back-up mode when no network is available.
  • - Solar inverter which requires the use of optometers for proper installation and operation.
  • - Grade of protection IP65
  • -Small, lightweight inverter easy to install.

The most relevant electrical parameters of the inverter are shown below. For further information, see the attached data sheet:

Model

SIX THOUSAND HOURS

EXIT

 

Rated AC power output

6000 W

Maximum power output of AC

6000 GOING

In the case of a power-generating module, the power consumption shall be calculated as the rated power output

220/230 Vac

AC output voltage range

MANUFACTURE FROM MATERIALS OF ANY HEADING

AC frequency (nominal)

For the purposes of this Regulation, the following definitions shall apply:

Maximum direct current output

27,5 TO

Power factor

1, adjustable to -0. 8 to 0. 8

Monitoring of utilities, protection of islands, configurable power factor, configurable thresholds by country

I did

ENTRY

 

Maximum power of DC

12000 W

No transformer, no ground connection

I did

Maximum input voltage

480 Vdc

Rated DC input voltage

380 Vdc

Maximum input current

16.5 A

Protection from reverse polarity

I did

Detection of ground fault insulation

600 kΩ

Maximum efficiency of the inverter

99.2%

European weighted efficiency

99 percent

COMPLIANCE WITH STANDARDS

 

Security

THE FOLLOWING POINT IS INSERTED:

Network connection standards

FOR THE PURPOSES OF THIS REGULATION, THE FOLLOWING DEFINITIONS SHALL APPLY:, TF3.2.1, C10-11, POINTS 097-2-1

Electromagnetic compatibility (EMC)

In the case of vehicles of categories M1 and N1 with a maximum mass not exceeding 2000 kg:

INSTALLATION SPECIFICATIONS

 

AC output: compatible cable diameter

9-16 mm

AC - Cross section of compatible wire

1 to 13 mm^2

DC input (PV)

3 x MC4

Dimensions (H x W x D)

459 x 370 x 154 mm

Noise

Other, not further worked than hot-rolled

Weight

containing by weight:

Cooling

Natural convection

Operating temperature range

-40 to +60 °C

Degree of protection

IP65 — Exterior and interior

 

SE5000H

Data sheet

Power (kW)
3 - 5.9
Phase Type
Single phase
Inverter Type
Hybrid

Specific References