Hybrid Inverter own consumption Ingeteam Ingecon Sun Storage 6TL M
  • Hybrid Inverter own consumption Ingeteam Ingecon Sun Storage 6TL M

Hybrid Inverter own consumption Ingeteam Ingecon Sun Storage 6TL M

Hybrid Inverter own consumption Ingeteam Ingecon Sun Storage 6TL

The Sun Storage 6TL has 4 modes of operation and can be used in isolated and grid connected systems, up to a maximum solar power of 10,000 Wp. This inverter also has a technology that controls the charging and discharging of the storage system, lengthening the maximum life of the battery system.

Hybrid Inverter own consumption Ingeteam Ingecon Sun Storage 6TL

Operating modes:

- Isolated Mode

It works independently thanks to the input from photovoltaic solar panels. The inverter creates an independent alternating current grid. The energy generated goes directly to the loads, what can increase the battery life. And if some surpluses are produced they are stored in the battery bank and used when the generation is not sufficient. You can connect an auxiliary source that supplies only when the battery status drops below a limit.

- Back-up mode

This mode is used in grid-connected systems where the grid is not very reliable. The inverter is connected to the grid and keeps the batteries charged; in case of failure this generates the internal AC grid for the house with the battery power. It can be used for peak shaving strategies, hence reducing the required contracted power.

- Consumption mode

For grid connected systems intended to reduce the consumption of electricity from the utility. If generation from PV panels household exceeds demand, the surplus is stored in batteries, and always the energy of these batteries is used again instead of using the grid, so the consumption ratio is increased. If the batteries are charged, allows injection of electricity into the grid. It can also be implemented to enable peak shaving strategies aimed to reduce the contracted power and save on the fixed term of the bill.

- Grid mode support

If used in conjunction with the INGECON EMS Manager it allows you to set the output value of photovoltaic power to suit the needs as required.

The Sun Storage can feed Ingecon household consumption directly from photovoltaic panels bypassing the batteries. In case there is surplus this can go as storage batteries for use when the generation does not cover consumption.

It has a battery management system, allows you to connect an auxiliary generator, also has a photovoltaic entry, and it is 100% compatible with Ingecon Sun and Ingecon Wind.

The bank of batteries voltage recommended is 72 V (for example 6 batteries in parallel 12V), but can work on battery banks voltages between 48 and 320 V.

You can use off-grid photovoltaic panels or grid connected panels, in any case they must provide at least 300 Vdc. It has two inputs, but can only use one.

3 years warranty expandable to 25 years.

 

CHARACTERISTICS

PV input (DC)
Maximum power                                         10 kWp
MPP voltage range                                    330-450 V
Voltage range                                             300-550 V
Maximum current                                          30 A
Number of DC input                                        2
MPPT trackers                                                1

Batteries input (DC)
Battery rated voltage                                   96-330 V
Extended battery voltage                             96-420 V
Minimum operating voltage of                        40 V
Load / maximum discharge current                 50 A
Battery Type                                        Lead, Ni-Cd, Li-ion

Input Generator / Red (AC)
Rated voltage                                               230 V
Voltage range                                            172-264 V
Rated frequency                                          50/60 Hz
Frequency range                                          40-70 Hz
Load current range                                       0-26 A
Maximum power generator or network            11,500 W

Output values (AC)
Rated power                                                  6 kW
Power (25 ° C) 30 min, 2 min, 3 s (5)     6.400 / 6.900 / 7.980 W
Current                                                         26 A
Rated voltage                                             220-240 V
Rated frequency                                           50/60 Hz

Performance
Maximum efficiency                                        96%

General data
Stand-by                                                       <10 W
Operating temperature                            -20 ° C to +65 ° C
Relative humidity (non-condensing)                  0-95%
Protection level                                               IP65

IGTM SS6TL

Data sheet

Power (kW)
6 - 9.9
Phase Type
Single phase
Max Current Input (A)
20+
Compatibility list
Pylontech US2000C / US3000C / US5000
Compatibility list
Dyness BX51100
Compatibility list
Dyness Power Box
Compatibility list
Pylontech US5000 / Force L2
Compatibility list
Pylontech US3000C
Compatibility list
Pylontech Force L2

Specific References

Download

Manual Ingecon Sun Storage ES

Download (3.08MB)

Garantia

Ingeteam_Warranty

Download (58.94KB)

Manual

Ingeteam_Manual

Download (3.3MB)